Просмотр информации о документе
Название:
Connection between the load energy and the taper of cut at abrasive waterjet cutting
Коллекция:
Збірники наукових праць НТУ "ХПІ" » Різання та інструмент в технологічних системах
Авторы:
Кафедра:
Издатель:
Год публикации:
ISBN/ISSN:
2078-7405
Вид документа:
стаття
Язык документа:
англійська
Добавлен в архив:
25.11.2013
Сводная информация по документу:
Connection between the load energy and the taper of cut at abrasive waterjet cutting [Текст] / Maros Z. // Збірники наукових праць НТУ "ХПІ" : Різання та інструмент в технологічних системах №81 - НТУ "ХПИ", 2012. - ISBN 2078-7405
Постоянная ссылка:
Аннотация:

вiдсутня

отсутствует

Accuracy of abrasive waterjet cutting mainly depends on the form of cutting gap. It is very difficult to keep in hand the taper of the gap and produce almost parallel cut surfaces. There are lot of parameters effect on the form of gap, and complex investigation of them were not published in the literature. Some results of research work carried out on an aluminium alloy related to the taper of the cutting kerf are explained in this paper, mainly from point of view of the load energy which effect to the surface of the workpiece during the abrasive waterjet cutting.


© 2020 — Разработано лабораторией информационно-поисковых систем НТУ "ХПИ"